|Applications:?||Direct access color selection and functions with dimmable and speed controls|
|Function:||Control 3 channel RGB LED products using wireless remote|
|Operating Voltage:??||12 Volts DC|
|Connection Mode:??||Common Anode (+)|
|Output:?||Three CMOS drain-open output|
|Maximum Load Current:??||4 Amps/channel (12 Amps total)|
|Output Power:?||144 Watts|
|Overall Size:?||(L)114 X (W)64 X (H)25 mm|
|Control Method:?||Wireless RF Remote Control|
|Batteries Required:||27A, 12V battery for Remote (included)|
|Modes:||14 total (8 static and 6 dynamic) see desc. below|
1.) Only power with 12VDC Power Supply and connect to 12 Volt Light Strips or unit will be damaged. Our Compact 50Watt and 24 Watt Power Supplies will plug into DC IN jack on left side of unit. Our Enclosed Power Supplies can be direct wired to “+” and “-” terminals on removable Green connector on right side of unit.
2.) Wireless controller uses one 23A, 12V battery.
3.) Connect according to the above drawing and note that the Green Connectors can be unplugged from the unit.
4.) Red LED will come on when unit is receiving power, Green LED will flash when RF signal is received from handheld transmitter.
5.) UP and DOWN buttons will only work when unit is in one of the four color-changing (dynamic) modes.
6.) Each Controller has a handheld Remote matched to it and will only work with it’s matched Remote. One Remote cannot operate multiple Controllers.
7.) Controller can control a maximum of 30 feet of our Flexible RGB LED Strip. Over 30 feet, the Strips have to connect with an amplifier to reinforce the transmission of signal. Use one RGB Amplifier for every 30 feet of additional LED Strips.
8.) Do not exceed 80% of Power Supply capacity when calculating Power Supply size to use in your system.
RF Remote Control
Dimensions in millimeters (inches)