LDRF-WRGB3 Weatherproof RGB Controller w/ RF Remote-Strip Modules Source



LDRF-WRGB3 Weatherproof RGB Controller w/ RF Remote

Applications:?Specific color selection or color change with speed control modes for accent lighting
Function:Control 3 channel RGB LED products using wireless remote
Operating Voltage:??12~24 Volts DC
Connection Mode:??Common Anode (+)
Output:?Three CMOS output RGB
Maximum Load Current:??3 Amps/channel (9 Amps total)
Output Power:?108 Watts
Overall Size:?(L)109 X (W)42 X (H)77 mm
Control Method:?4 button wireless RF Remote Control
Batteries Required:23A, 12V battery for Remote (included)
Modes:11 total (7 static and 4 dynamic) see desc. below
Operating Temperature:-25~60°C

Static and Dynamic Color Modes



1.) Wireless controller uses one 23A, 12V battery.
2.) UP and DOWN buttons will only work when unit is in one of the four color-changing (dynamic) modes.
3.) Each Controller has a handheld Remote matched to it and will only work with it’s matched Remote. One Remote cannot operate multiple Controllers.
4.) Controller can control a maximum of 20 meters of our Flexible RGB LED Strip. Over 20 meters, the Strips have to connect with an amplifier to reinforce the transmission of signal. Use one RGB Amplifier for every 30 meters of additional LED Strips.
5.) Do not exceed 80% of Power Supply capacity when calculating Power Supply size to use in your system.

RF Remote Control

RGB Light Bars & StripsUniversal RGB Controllers and Dimmers
Numbers below represent the maximum number of units the controller can drive without the use of RGB amplifiers
RGB Amplifiers
Numbers below represent the maximum number of units the Amplifier can drive
ProductCurrent Draw @ 12 Volt DCProduct LengthMax Run*LDRF-WRGB3RGB-A4RGB-WA4MRGB-A4MRGB-A4-CPSRGBW-A6
RGB-1-DI230ma0.305m (1ft)203952525252104
NFLS-RGB15-DI202ma0.5m (1.6ft)204459595959118
NFLS-RGB30-DI404ma1m (3.3ft)10222929292959
NFLS-RGB150-DI1855ma5m (16.4ft)24666612
NFLS-RGB150X23295ma5m (16.4ft)1233337
NFLS-RGB150-KIT1970ma5m (16.4ft)24666612
NFLS-RGB30X2-WHT808ma1m (3.3ft)5111414141429
NFLS-RGBNW300X3-WHT4700ma5m (16.4ft)1122225
NFLS-RGBWW300X3-WHT3750ma5m (16.4ft)1233336
* Maximum number of light bars in one run (end to end) – for higher quantities, multiple runs back to the power supply, controller, or amplifier must be made to prevent excessive voltage drop Note: To determine the maximum number of any LED products on a single Power Supply – divide the total current capability of the power supply by the current draw of the LED product – then multiply that number by 0.8 (for 80% capacity)
Product Specifications
Amps9.00 AmpsAmps per Channel3 Amps/CH
IP RatingWeatherproof IP66Remote[1]Radio Frequency/Single Device Pairing
Standards And CertificationsCE/FCC/ROHS CompliantSuitable for VehiclesYes
TypeRGB ControllerWire Length21.6cm(8.5in)